Fog seal

Fog seal

A fog seal is a light application of a diluted slow-setting asphalt emulsion to the surface of an aged (oxidized) pavement surface. Fog seals are low-cost and are used to restore flexibility to an existing HMA pavement surface.

They may be able to temporarily postpone the need for a surface treatment or non-structural overlay.
Purpose Preventive maintenance. Fog seals are used to restore or rejuvenate an HMA surface. They may be able to postpone the need for a BST or non-structural overlay for a year or two.
 
Materials
Slow-setting asphalt emulsion.
 
Mix Design
None beyond the manufacturer’s. A test patch may be needed to determine the proper application rate.
 
Other Info
Fog seals are suitable for low-volume roads which can be closed to traffic for the 4 to 6 hours it takes for the slow-setting asphalt emulsion to break and set.
An excessive application rate may result in a thin asphalt layer on top of the original HMA pavement. This layer can be very smooth and cause a loss of skid resistance. Sand should be kept in reserve to blot up areas of excess application.
 
BS group is ready to provide suitable asphalt emulsion and give you advice for having best results in this project.

Contact information

BS group provides wide range of bituminous products and offers road maintenance solutions to clients base on their needs
Address: No1, Mobtakeran 4 St, Birjand industrial zone, Iran
Phone: +98-5632255131
Phone: +98-9153623260
Phone: +98-9151638565
Fax: +98-5632255130
Email: bsgroup.ir@gmail.com